陈见行,曾班全,张俊文. 冲击荷载下加卸载效应对冲击性岩石力学特性的影响[J]. 煤炭学报,2024,49(5):2283−2297. DOI: 10.13225/j.cnki.jccs.2023.0572
引用本文: 陈见行,曾班全,张俊文. 冲击荷载下加卸载效应对冲击性岩石力学特性的影响[J]. 煤炭学报,2024,49(5):2283−2297. DOI: 10.13225/j.cnki.jccs.2023.0572
CHEN Jianhang,ZENG Banquan,ZHANG Junwen. Influence of loading and unloading effect on mechanical properties of impact rock under impact load[J]. Journal of China Coal Society,2024,49(5):2283−2297. DOI: 10.13225/j.cnki.jccs.2023.0572
Citation: CHEN Jianhang,ZENG Banquan,ZHANG Junwen. Influence of loading and unloading effect on mechanical properties of impact rock under impact load[J]. Journal of China Coal Society,2024,49(5):2283−2297. DOI: 10.13225/j.cnki.jccs.2023.0572

冲击荷载下加卸载效应对冲击性岩石力学特性的影响

Influence of loading and unloading effect on mechanical properties of impact rock under impact load

  • 摘要: 为研究矿井基本顶周期来压对冲击性矿柱动力学特性的影响,采用一维动静组合加载SHPB实验装置对循环加卸载预处理过的冲击性砂岩开展动态冲击实验,实验中预先设置3种不同的轴向循环阈值:6、12、18 MPa,然后进行不同冲击气压条件下的动态压缩实验。探讨了不同循环阈值和冲击气压下冲击性砂岩动态力学响应特性、能量演化规律及碎块分布特征。研究结果表明:岩样动态应力−应变曲线整体划分为弹性阶段、屈服阶段和破坏阶段。动态应力−应变曲线起始阶段近似直线,不存在静态单轴压缩中的裂隙压密阶段。平均动态抗压强度、平均动态弹性模量和平均动态变形模量随循环阈值增大先增大后减小;而平均动态峰值应变随循环阈值增大先减小后增大。临界阈值处岩样平均动态抗压强度、平均动态弹性模量和平均动态变形模量最大,平均动态峰值应变最小。反射能和耗散能密度随循环阈值增大先减小后增大;而透射能随循环阈值增大先增大后减小。临界阈值处岩样反射能和耗散能密度最小,透射能最大。冲击荷载下岩样呈4种破坏形态:粉碎破坏、岩块碎裂、岩块侧面剥落脱离、岩块劈裂。各冲击气压下岩样分形维数随循环阈值增大先减小后增大,随耗散能密度增加呈非线性增长。冲击性岩石致密性越好,冲击破坏时剧烈程度越弱,碎块块度越大,耗散能密度越小,分形维数越小。研究结果表明矿井基本顶周期来压小于冲击性矿柱损伤门槛值时,周期来压可提高岩层密实性,进而影响动态冲击时的破坏程度。

     

    Abstract: In order to study the effect of basic roof period pressure on the dynamic characteristics of impact pillar, one-dimensional dynamic and static combined loading SHPB experimental device is used to carry out dynamic impact experiment on the impact sandstone pre-treated by cyclic loading and unloading. In the experiment, three different axial cycle thresholds are pre-set: 6, 12, 18 MPa, and then carry out dynamic compression experiments under different impact pressure conditions. The dynamic mechanical response, energy evolution and fragmentation distribution characteristics of impact sandstone under different cycle thresholds and impact pressure are discussed. The results show that the dynamic stress-strain curve of rock samples can be divided into elastic stage, yield stage and failure stage. The initial stage of dynamic stress-strain curve is almost straight line, and there is no fracture compaction stage in static uniaxial compression. The average dynamic compressive strength, the average dynamic elastic modulus and the average dynamic deformation modulus first increase and then decrease with the increase of the cyclic threshold. The average dynamic peak strain decreases first and then increases with the increase of cycle threshold. The average dynamic compressive strength, average dynamic elastic modulus and average dynamic deformation modulus of rock samples at the critical threshold are the largest, and the average dynamic peak strain is the smallest. The density of reflected energy and dissipated energy decreases first and then increases with the increase of the cycle threshold. The transmission energy increases first and then decreases with the increase of the cycle threshold. At the critical threshold, the density of reflected energy and dissipated energy is the smallest and the transmitted energy is the largest. There are four kinds of failure modes of rock samples under impact load: crushing failure, rock fragmentation, rock side spalling and rock splitting. Under each impact pressure, the fractal dimension of rock samples decreases first and then increases with the increase of cycle threshold, and increases nonlinearly with the increase of dissipated energy density. The densification of impact rock is better, the intensity of impact failure is weaker, the fragmentation degree is larger, the dissipated energy density is smaller, and the fractal dimension is smaller. The research results show that when the basic roof period pressure is less than the damage threshold value of the impact pillar, the periodic pressure can improve the rock density and affect the damage degree of the dynamic impact.

     

/

返回文章
返回