CO2−碱性水对烟煤物化协同损伤效应及其作用机制

Synergistic damage effects and mechanism of CO2-alkaline-water on physicochemical properties of bituminous coal

  • 摘要: CO2驱替CH4时易在煤层内富集是制约煤层注气增产技术的关键难题,常规煤层注水时水分难以进入微孔内部致使注水效果不理想。CO2−碱性水两相驱气润煤技术是近年新提出的一项防突措施,该技术可以显著促进煤层甲烷采收,并消除CO2突出危险。但与此同时,煤中残余CO2和碱性水均会对煤体造成溶蚀效应。为了掌握CO2−碱性水协同损伤煤体作用规律,利用X射线衍射、水质分析、扫描电镜、低温CO2吸附、单轴压缩实验及声发射特征测试等多种手段,研究了CO2−碱性水耦合作用下煤体矿物成分、孔隙结构及力学强度的损伤特征。结果表明:① 相比于常规煤层注水,采用CO2−碱性水两相驱气润煤后,煤体受到残余CO2溶于水形成的碳酸和碱性水的酸+碱双重侵蚀作用和更强的水分溶蚀作用,煤中矿物的溶蚀程度明显提高,烟煤中矿物质的溶解量明显增加,高岭石和白云母等矿物质的含量明显降低。此外,含CH4煤直接注水后,LS烟煤溶出液中离子成分以\mathrmHCO_3^- 离子为主,其质量分数为63.89%;而CO2−碱性水两相驱气润煤后,溶出液中\mathrmHCO_3^- 离子消失,Na+、\mathrmCO_3^2- 、K+、\mathrmNH_4^+ 及Cl等离子含量则显著增加,其中\mathrmCO_3^2- 离子质量分数为57.57%。② 相比于直接注水,CO2−碱性水两相驱气润煤后,LS烟煤孔隙结构明显发育,孔隙数量明显增加且孔径增大,部分孔隙贯通并形成明显的沟状裂隙结构。单一的水侵作用对烟煤微孔结构的损伤效果较小,CO2−碱性水耦合作用则会对烟煤微孔造成较强的溶蚀作用,煤体受到的 “增孔”和“扩孔”效应更强,LS烟煤内微孔的比表面积和总孔隙体积分别增加了1.77%和3.63%。③ 相比于常规注水,采用CO2−碱性水两相驱气润煤后,烟煤的力学强度明显降低,LS煤样的弹性模量、单轴抗压强度及累积能量分别降低了57.35%、45.99%、22.83%。研究成果可以为突破煤层注气增产技术瓶颈、防治煤与瓦斯突出危险提供重要参考。

     

    Abstract: During gas displacement, CO2 enrichment is the key challenge restricting the field application of CO2 enhanced coalbed methane recovery (CO2-ECBM). For conventional coal seam water injection, it is difficult for injected water to enter the micropore, resulting in an unsatisfactory water injection effect. The CO2-alkaline-water two phase displacing gas and wetting coal (the CADW) method is proposed in recent years, which can significantly promote the coalbed methane recovery efficiency, effectively eliminate the CO2 outburst risk, and improve the coalbed water injection effect. However, both the carbonic acid, formed by the residual CO2 dissolution, and alkaline-water will cause obvious dissolution effects on coal. To grasp the synergistic damage effect of CO2-alkaline-water, the damage characteristics of mineral composition, pore structure and mechanical strength of bituminous coal were studied using various techniques, including the X-ray diffraction, water quality analysis, SEM, low-temperature CO2 adsorption, uniaxial compression experiment and acoustic emission characterization test. The results showed that: ① Compared with conventional coal seam water injection, after using the CADW, coal was subjected to double erosion of carbonic acid, formed by residual CO2 dissolution, alkaline-water and stronger water dissolution, the dissolution degree of coal minerals was obviously improved. The dissolution of minerals in bituminous coal increased evidently, the contents of minerals such as kaolinite and muscovite decreased distinctly. After direct water injection, \mathrmHCO_3^- was the main ion component in the leaching solution of LS bituminous coal, accounting for 63.89% of the total ions. However, after the CADW, the \mathrmHCO_3^- disappeared, while the contents of Na+, \mathrmCO_3^2- , K+, \mathrmNH_4^+ and Cl ions increased sharply, and the content of \mathrmCO_3^2- accounted for 57.57% of the total ions. ② Compared with direct water injection, after adopting the CADW, the pore structure of bituminous coal was developed obviously, the number and size of pores were increased clearly. Some pores connected and formed obvious grooved fracture structure. Single water invasion had little influence on the micropore structure of bituminous coal, while the CO2-alkaline-water had a strong coupling dissolution effect on the micropores of bituminous coal, which was subjected to strong “pore-enlargement” and “pore-expansion” effects. The specific surface area and total pore volume of micropores in LS coal increased by 1.77% and 3.63% respectively. ③ Compared with conventional water injection, the mechanical strength of bituminous coal was reduced significantly after using the CADW. The elastic modulus, uniaxial compressive strength and cumulative energy of LS coal were reduced by 57.35%, 45.99% and 22.83%, respectively. The research results can provide important references in breaking through the technical bottleneck of the CO2-ECBM and preventing coal and gas outburst risk.

     

/

返回文章
返回